DC Charger User Interface Guide

Modified on Thu, 12 Dec, 2024 at 4:53 PM

TABLE OF CONTENTS

1. Start Charging

1. Take off the connector and plug it into the Electric Vehicle.

2. Tap on the plug with status "Preparing".

3. Swipe the RFID card to start charging.

If RFID is not authorized, display will indicate:

If the RFID is authorized, display will indicate:

If the charger is connected to a OCPP system, please refer to the instructions presented by the CPO.

1. Either stop the charging process on the EV side or press on the relevant connector on the display and swipe the RFID that was used to start it.

2. Once charging stopped and connector is unlocked from the CCS2 inlet, unplug the connector from the EV.

1. Tap on the blank space at the upper left of the display. Login screen will appear.

2. Tap on the password text field and enter the password using the on-screen keyboard.

3. Tap on "Charge Setting" and choose "Authorize Mode" - either Online or Offline.

4. Tap on "Save". Display will indicate:

After the charger finishes restarting, it will be ready to use.

1. Login to the configuration menu in the same manner as previously.

2. Set the "Authorize Mode" to Online as described in the previous section.

3. Tap on "System Setting". Chose either Static IP or DHCP, and enter the full URL of the OCPP server.

OCPP URL should include connection type (ws:// or wss://) and OCPP ID. E.g.:
"wss://ocpp.central.system/{OCPP_ID}".

4. Tap on "Save". Device will display a confirmation and restart.

After restart is finished, charging authorization will be managed by the OCPP system.

During an active charging session, tap on the relevant plug on the display to view time, SOC, energy and power information.

If you encounter any issues or have questions, please Submit a ticket.