Configuration Guide for Plug&Go Model

Note: This guide is only for Plug&Charge models. Do not alter the switch settings on Smart Charger models.

Power Downgrade Options for Plug&Go Models

Since Plug&Go models lack connectivity, power downgrade can be achieved in two ways:

1. Using a DIP switch inside the charger.
2. Wiring the 3-phase charger to a 1-phase power source.

Accessing and Adjusting Output Power

Locate the DIP Switch
The DIP switch is situated under the LCD/LED panel, just above the input power connection terminals inside the charger.

• Remove the front cover to access the switch, as shown in the reference image.

DIP Switch Settings
Use the following switch settings to configure the charger:

• DIP1
  • OFF: Activates the socket version.
  • ON: Activates the cable version.

• DIP2
  • OFF: Sets the maximum current to 16A.
  • ON: Sets the maximum current to 32A.

• DIP3
  • OFF: Enables plug-and-charge mode.
  • ON: Enables RFID mode.

 DIP "ON" IS UP, DIP "OFF" IS DOWN

ON OFF

For additional assistance or to report an issue, please Submit a ticket.